Q Light Controller+

• When selecting a channel with [1] [ENTER] and pressing [FULL] [ENTER], the DMX value of the channel is set to 0, not 255.
• When setting a channel to full value with [2] [FULL] [ENTER] and clicking [ENTER] (therefore sending an empty command), the DMX value of the selected channel (in this case channel 2) is set to 0.
• The Plus and Minus buttons don't work.

(QLC+ 5 Beta 3, Ubuntu)

You need to do "1 ENTER" and then "AT FULL"
For "+/-" I need to check but the supported syntax is "2 +% 15" to increase by 15% or "42 -% 30" to decrease by 30%

The only real bug I see here is the "ENTER" which sends an empty command. That should not be allowed