Q Light Controller+

Hi, everytime i am using qlc+ i start it via the command line. When i have two network cards, it seems like the web interface listens only to the network card with the higher windows Priority. In windows 10 it was possible to change the priority to switch to the right network card for qlcplus but in windows 11 this feature is not available anymore.

Any idea how i can define the network card for the web interface in qlc+ Directly?

The socket for the web interface binds to the 'any' address for both IPv4 and IPv6. So it will bind to '0.0.0.0' and '::'. The result is that it will be available on all interfaces available on your host. So in the case of two network cards with both an IP assigned, it will be available on both IPs. Is this the behavior you are seeing?

For this reason, most users do not have to choose a network card. And I don't believe there is a way to tell QLC+ the interface to bind to. What's your use case for this?