Q Light Controller+

Hello,

I’m experiencing an issue with QLC+. I have an Art-Net node configured as an output, and it works perfectly when using the broadcast address. However, when I switch to unicast by setting the IP to the Art-Net node’s address, I lose control of the lights.

I tested the same Art-Net node in Daslight, and everything works fine there.

Any ideas on what might be causing this?


Working Config Not Working Nodes:

Just to be sure: you can ping your 10.0.6.201 interface right?
The thing with broadcast is that every listener to the MASK setting will get the stream, as per Unicast, it's only sent to one client.